SUPER 12/RC Business Card Slitter

 

 

 

  • Simplicity

  • Hairline Accuracy

  • Maximum Durability!

Super 12/RC

 


SUPER 4/RC: Print cards on a strip of stock 3.5" wide. Typeset cards so that up to a 3/8" gripper edge is left at the top and 1/8" trim at the bottom. Cards are placed in feed section and friction fed onto alignment table. After being registered, cards are then conveyed into knives, where they exit into the separators arms. Finally, cards are delivered neatly onto a slow moving fan out section. SUPER 12/RC: Run 12 up cards on 8/5" x 11" stock. The first pass trims the outside perimeters and cuts the stock into three 8.5" x 3.5" strips. The operator then transfers 8.5" x 3.5" stock onto the 4-up side of the slitter, cutting up to 144,000 business cards per hour. Both feeders can be operated simultaneously.

SLITTER SPECIFICATIONS

MODEL NO. SUPER 4/RC SUPER 6/RC SUPER 12/RC
Feed System Top Feed/Friction Top Feed/Friction Duel Top Feed/Friction
Feed Speeds 36,000 4-up Sheets per hour 36,000 6-up Sheets per hour 12,000 12-up Sheets or 36,000 4-up sheets per hour
Knives Spring Loaded/knife to knife cut/cassette Spring Loaded/knife to knife cut/cassette Spring Loaded/knife to knife cut/cassette
Drive DC Variable Drive/1/4 H.P., 1725 RPM DC Variable Drive/1/4 H.P., 1725 RPM DC Variable Drive/1/4 H.P., 1725 RPM
Maximum Paper Size 8.5" x 3.5" 12.5" x 3.5" 8.5" x 11"
Card Spec 2, 3 & 4-up 2, 3, 4, 5, & 6-up 2, 3, & 4-up, 8-up or 12-up
Electrical 110 Volt, 3 Amps/60 Cycle 110 Volt, 3 Amps/60 Cycle 110 volts, 3.0 amps/60 cycle
Warranty 2 years/all parts excluding knives and feed rollers 2 years/all parts excluding knives and feed rollers 2 years/all parts excluding knives and feed rollers
Shipping Weight 500 lbs. 510 lbs. 520 lbs.
Floor Space Length  70 in.
Height   42 in.
Width    24 in.
Length  70 in.
Height   42 in.
Width    24 in.
Length  70 in.
Height   42 in.
Width    24 in.